Defective Locks

Cutting discs are clamped into this mandrel and can then be used for various tasks with the help of the straight grinder. For example, cutting the door hinges, processing a duplicate key and much more. Supplied with: Mandrel

76 x 1.0 x 10mm for Mandrel
 

50 x 1.0 x 6mm for Mandrel Mini

Mandrel for Cutting Disc Mini 50 x 1.0 x 6mm
 

Supplied with::
1 Carbide - Hole Saw Ø25mm
   inkluding Shank and magnetic spacer
1 Carbide Drill
1 prepared 10mm drill
2 High Grade Stainless Steel Hooks

Procedure brocken Latch:
1) Remove the front plate
2) The square socket opening serves to centre the Hole Saw to help remove the nut.
3) The opening that is created allows you to use the special stainless steel hooks to pull back the latch, even if the latch is jammed.

Procedure brocken Bolt:
1) Drill a center hole with the carbide drill.
2) Then use the Carbide Hole Saw to drill a hole through the face plate, the door and the metal sheet of the lock.
3) The opening that is created allows you to use the special stainless steel hooks to pull back the bolt, don't forget to lift the tumbler.

For doors with too little rebate clearance between the frame and the door leaf, the necessary rebate clearance can be created with this tool. Works excellently with foamed wood and plastic frames. 60cm in length, can be extended up to 100cm, additional 10cm expanding thread can create 110cm maximum.